35L Stillmate 4 x 3" Crystal Clear Bubble Plate Still

Description:

This is 4 x 3″ bubble plates Crystal clear modular still with 35L Digi boiler & lid for making moonshine/spirits.

This rig is the ultimate in distilling for those that want one still that can do it all, each plate means each distillation process to refining the spirits as neutral as it can. In principle the more plate you use the more neutral it will be, but it make less sense after 4 still/plate. However, we can supply extra still plate modular/bubble tee to add-on yourself if you want a better setup for more purier spirits.

This still come with is a 30cm heavy-duty stainless steel dome/lid, and it will fi t35L digi boil showed in picture. The 35L digi boiler is made for 240V/10amp/2400W(500w+1900w) power capacity, thus you have choice to adjust the heating rate by using one of them, or a combination of each to suit your needs. In general, you can run full power when pre-heat before start of distillation, while it’s better just run about 1900W when distilling your spirits.

This still has a short reflux condenser on top of 4 x bubble plates, and has a long condenser as the main pot still condenser. With the 4 of 3 inch bubble plates the distillation shall run as 4 times of distillation/refining so that you will get more high quality of spirits you want.

The Kit comes with push-in tubing for connection of cooling water and water out. All the pipes can push in to fit the condenser with water flow adjustable valve.

Features:

• Made of high-quality stainless steel
• 4x 2″ Crystal clear bubble plate column with 2″ tri-clover fitting to fix
• Push-in fittings for cooling water in/out
• Heavy-Duty stainless steel dome/lid with 3″ tri-clover fittings
• Dual Thermometer which has 1 graduated degree

Packaging:

• 4 X 3″ Crystal clear whole set bubble plate
• 2 X Dial Thermometer
• 1 X Long Gun Condenser
• 1 X Shot Gun Condenser
• 1 X Parrot Complete Assembly
• 1 X Top U Bend
• 1 X Parrott extension
• 1 x 35L Digiboil boiler
• 1 x Heavy duty lid with 3″ TC to support column
• 1 set of cooling water hose with push-in fittings and valve
• All tri-clover seals and clamps required