Temperature controlled Heating Pads 25W

This is an Australian Safety Approved 25W homebrew heating Mat. It is one of the best tools to keep your brew warm in cold winter.

This heating mat has built-in temperature controller and a probe to stick to the fermenter, and the heating rate can be adjusted.

The 25W heating capacity will be just good to keep your fermenter warm but not overheated in short time.

This heating mat was designed for indoor use, not suitable for outdoor use.

Instructions – Setting Temperature:

1. Press the power button to turn the device on/off.
2. To set the temperature press the “up” and “down” arrows to increase or decrease the set temperature.

Instruction – Change C (Celsius) to F (Fahrenheit):

1. Press the set ↵ button to alternate between until the units change from C to F.

Instructions – Change Power Level:

1. Press the ↵ button until you see L01.
2. Once the L01 is displayed press “up” and “down” arrows until the desired percentage is reached.

• L01 = 10%
• L02 = 20%
• L03 = 30%
• L04 = 40%
• L05 = 50%
• L06 = 60%
• L07 = 70%
• L08 = 80%
• L09 = 90%
• L10 = 100%

Instructions – Timer Function:

1. Press the ↵ button until you see 0H.
2. Change the 0H setting using the “up” and “down” arrows to increase from 0H to 24H.

During this mode the heating will stay on until the a certain number of hours elapses.

For instance if you set 5H then the controller will turn on for 5 hours and will then the heating function will turn off.

When in timer mode the power button will flash on and off. When the XH time has finished the heating will turn off and the whole screen will flash on and off to indicate the timing cycle has completed.

Note: 0H = On all the time.

Warnings:

• NOT INTENDED FOR OUTDOOR USE
• DO NOT IMMERSE IN WATER OR OTHER LIQUIDS
• KEEP AWAY FROM CHILDREN
• AVOID DIRECT SUNLIGHT
• AVOID CONTACT WITH ANYTHING HIGHER THAN 60°C